Rack Mounting; Rack Mounting The System Control Unit Mks-8010A - Sony MKS-8010A Installation Manual

Center control panel pack
Hide thumbs Also See for MKS-8010A:
Table of Contents

Advertisement

1-7. Rack Mounting

1-7-1. Rack Mounting the System Control
Unit MKS-8010A
The MKS-8010A installs in a 19-inch standard rack.
To mount the MKS-8010A in a rack, use the specified rack
mount kit and follow the procedure described below.
Specified rack mount kit : RMM-10
n
If a rack mount kit other than the specified one is used, the
unit may not correctly install in a 19-inch standard rack.
Parts of the RMM-10
. Rack tools
. Right rack mount adaptor
. Left rack mount adaptor
. Rack tool attaching screws
(B4 x 6 : 7-682-560-09)
. Rack tool attaching screws
(B4 x 10 : 7-682-560-10)
1. Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolts or other fixings.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended
that a ventilation fan is installed to prevent temperature rise
inside the rack.
CCP-8000 IM
2. Rack mounting procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
n
Tighten the screws to the following torque.
Tightening torque : 120 x 10
1. Attach the rack tool to the side of the equipment using
2 pcs
1 pc
1 pc
6 pcs
6 pcs
2. Loosen the screws on the rear of the right and left
n
Maximum depth of adaptor : 750 mm
Minimum depth of adaptor : 595 mm
_2
the specified six screws.
n
Use B4 x 6 screws.
B 4x6
Rack tool
adaptors and adjust the length of the adaptor according
to the depth of the rack.
(The illustration below shows the left adaptor.)
Adaptor
Portion of the rail
N.m (12.2 kgf.cm)
B 4x6
Rack tool
B4 x 6
1-15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents