Sony MKS-8010A Installation Manual page 30

D131 (D-1) : USER
Used only for production in the assembly factory.
D132 to D147 (B-2) : MAIN CPU status LED
Main CPU module status indication.
Displays the initialization steps of the main CPU at power-
on.
"A0" is displayed when the initialization is completed and
the main CPU is booted correctly.
D148 (C-2) to D163 (B-2) : COM0 CPU status LED
CTRL LAN control IC status indication.
Displays the initialization steps of the COM0 CPU at
power-on. LED flashes rotatingly when the initialization is
completed and the COM0 CPU is booted correctly.
D164 (D-2) to D179 (C-2) : COM1 CPU status LED
PERIPH LAN control IC status indication.
Displays the initialization steps of the COM1 CPU at
power-on. LED flashes rotatingly when the initialization is
completed and the COM1 CPU is booted correctly.
1-22
<Switch>
S100 (B-1) : MAIN RESET switch
Reset switch for the entire this unit.
S101 (B-1) : C0-RESET switch
Independent reset switch for the CTRL LAN control IC.
S102 (C-1) : C1-RESET switch
Independent reset switch for the PERIPH LAN control sub
CPU.
S103 (B-1) : Monitor reset switch for the main CPU
Reset switch that is used during maintenance of the main
CPU from the TERMINAL pin.
S104 (C-1) : Monitor reset switch for the COM0 CPU
Reset switch that is used during maintenance of the CTRL
LAN control IC from the TERMINAL pin.
S105 (D-1) : Monitor reset switch for the COM1 CPU
Reset switch that is used during maintenance of the
PERIPH LAN control IC from the TERMINAL pin.
S106 (A-1) : Unit ID setting switch for LAN
Sets the unit ID of the equipment inside the network.
Used to set the unit ID for the CTRL, PERIPH and DATA
terminals.
Refer to the System Setup Manual for details.
S107 (A-1) : Group ID setting switch for LAN
Sets the ID of the network group.
Used to set the group ID for the CTRL, PERIPH and
DATA terminals.
Refer to the System Setup Manual for details.
S108 (A-1) : STATION ID
Used to set the REMOTE terminal.
Refer to the System Setup Manual for details.
CCP-8000 IM