How To Connect The Cables; Rack Mounting The Mks-8075A (Extension Adaptor) - Sony MKS-9011A Installation Manual

1-6-4. How to Connect the Cables

Parts used
. 50-pin cable supplied with the MKS-8075A
. SWC-5002 Panel cable (2 m)
. SWC-5005 Panel cable (5 m)
. SWC-5010 Panel cable (10 m)
. Shield plate assembly
. Screw (PSW2.6 x 5)
1. Connect the EXT PANEL connector of the control
panel MKS-9011A/9012A to the SCU IN connector of
the MKS-8075A using the panel cable SWC-5002/
5005/5010.
2. Connect the SCU OUT connector of the MKS-8075A
to the SCU IN connecor of the adjacent MKS-8075A
using the 50-pin cable supplied with the MKS-8075A,
as shown in the illustration.
3. Regard less of connecting the MKS-8075A or not,
terminate the SCU OUT connector of the MKS-8075A
with the shield plate assembly.
MKS-9011A/9012A
(Rear view)
50-pin cable supplied
with the MKS-8075A
MKS-8075A
CCP-9000A
EXT PANEL
SWC-5002/5005/5010
Shield plate
assembly
PSW2.6 x 5
MKS-8075A
1-6-5. Rack Mounting the MKS-8075A
(Extension Adaptor)
The MKS-8075A can be mounted in a 19-inch standard
rack.
To mount it in a rack, use the recommended rack mount
parts and follow the procedure described below.
n
In order to rack mount the MKS-8075A, the following
conditions must be met.
. Two or more adaptors must be configured to the two
rows as shown in the illustration by connecting them
horizontally together.
. Number of adaptors connected must be either 2 or 4.
. The connection method C (flat) must be used.
. For the connection method, refer to "1-6-3. How to
Connect the MKS-8075A".
Tools required
. Screws (RK5 x 16) for rack mounting
. Ornamental washers for rack mount
(Sony part No.: 2-297-913-01)
When 2 adaptors are connected : Each 4 pcs
When 4 adaptors are connected : Each 8 pcs
Precautions for rack mounting
w
. To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolts or other fixings.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
. Be sure to use the side panels of the adaptor itself for
rack mounting.
If not, injury may result and the equipment may fall due
to insufficient strength.
. After rack mounting, be sure to tighten the screws on the
side panels and fix the unit in the rack.
c
When mounting the unit in the rack, note the following:
. Be sure to mount in the rack with two persons or more.
. Mount in the rack in a stable position.
1-17