Cleaning - Sony MKS-8010A Installation Manual

3-2-2. Cleaning

Cleaning for control panel
Wipe the control panel, switches, and faders with a dried
cleaning cloth.
Use a cleaning cloth moistened with water or lukewarm
water for persistent stain.
n
Be sure to use a wrung cloth for wiping the control panel
since water droplet causes the malfunction.
Do not use any chemical, solvent, or cleaner, or wipe it
hard to avoid damaging it.
Front panel
The filter on the rear of the front panel of the MKS-8010A
can easily accumulate dust. Be sure to remove dust by
cleaning it about once in two months.
1. Remove the front panel. (Refer to Section 2-1.)
2. Remove the dust accumulated on the filter with a
vacuum cleaner.
n
Cleaning the filter by washing in water is recommend-
ed when there is a heavy accumulation of dust.
Be sure to dry the filter completely after it has been
washed.
Front panel
Filter
CCP-8000 IM
Fan
The inside of the MKS-8010A is cooled by a fan (side on
the rear).
If dust has accumulated in the intake of the fan, air is
prevented from flowing smoothly and this may result in a
temperature rise inside the machine. This may have an
adverse effect on performance and life of the machine.
Cleaning of the fan every month is recommended.
Contact your local Sony Sales Office/Service Center for
information cleaning the fan.
Fan
Track ball (MKS-8031ATB)
If the track ball becomes dirty, it may result in adverse
effects, typically the image does not move even though the
track ball is manipulated.
Cleaning the track ball every month is recommended.
1. Rotate the ball cover counter-clockwise and release the
lock. Then remove the ball cover.
2. Remove the track ball.
3. Clean the track ball and the portion shown by the
asterisk (*) in the illustration with a soft cloth.
4. Install the track ball and the ball over.
5. Rotate the ball cover clockwise until it is locked.
Release the lock.
MKS-8031ATB
MKS-8075A
Tighten the lock.
Ball cover
Track ball
*
3-3