Sony MKS-8010A Installation Manual page 36

*2 : Install the MKS-8042 in the following steps.
4. Install the MKS-8042 to the position where the opera-
tion module or the blank panel is removed in step 3.
Fix the left side with the supplied two screws (P3 x 6),
and the right side with the two screws (with drop-safe).
5. Install the module covers.
n
The MKS-8042 can only be installed to the right-most
side of each row. (Except when the MKS-8025MS
comes to the right-most side)
Module covers
P3 x 6
*3 : For the MKS-8031ATB, the track ball installation
work is required upon completion of the above steps 1
to 5. Install the track ball by following the procedure
described below.
6. Rotate the ball cover counter-clockwise and release the
lock.
7. Install the track ball and the ball cover.
8. Rotate the ball cover clockwise until it is locked.
2-4
Screws
(with drop-safe)
Connector
MKS-8042
Ball cover
Track ball
MKS-8031ATB
2. Installation to the AUX Panel
Applicable Modules
Refer to subsection "Applicable modules" of "1. Installa-
tion to the main panel".
Installation
1. Remove the panel covers (L) and (R) from both sides
of the operation module that you want to remove. (Pull
the operation panel up by inserting fingers into the
recessed handle on the sides.)
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Remove the operation module by holding the two
screws on the sides of the operation module.
4. Fit the operation module that you want to install into
the position as described in step 3. Fix the operation
module by tightening the four screws (with drop-safe)
on both sides.
5. Install the panel cover.
n
When two or more operation modules have already
been installed in the AUX panel, follow the procedure
as described in subsection "Applicable modules" of "1.
Installation to the main panel" to install the side that
sits next to the adjoining operation module.
Panel cover (L)
Operation module
Screws
(with drop-safe)
Panel cover (R)
Screws
(with drop-safe)
CCP-8000 IM