Sony MKS-8010A Installation Manual page 37

3. Installation to the MKS-8075A (Extension
adaptor)
Applicable modules
. MKS-8023AB Compact Key Transition Module
. MKS-8026A 10 Key Pad Module
. MKS-8030A
Key Frame Module
. MKS-8031AJS Joystick Module
. MKS-8031ATB
Track Ball Module
. MKS-8032A DKS Fader Module
. MKS-8033A
Utility/Shotbox Module
. MKS-8034ADK DSK/FTB Module
. MKS-8034AFB
FTB Module
. MKS-8035A Key Control Module
. MKS-8036A Device Control Module
. MKS-8040
Balnk Panel (1/3)
. MKS-8041 Balnk Panel (1/2)
. MKS-8042
Balnk Panel (1/6)
Installation
1. Remove the module cover on both sides of the opera-
tion module that you want to remove, as shown.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Remove the operation module by holding the two screws
on the sides of the operation module. (For the MKS-
8034ADK/8034AFB/8040/8023AB/8042, go to *2.)
4. Fit the operation module that you want to install into
the position as described in step 3. Fix the operation
module by tightening the four screws (with drop-safe)
on both sides.
5. Install the module cover. (When you want to install the
MKS-8031ATB, go to *1.)
Module covers
Screws
(with drop-safe)
MKS-8075A
CCP-8000 IM
*1
Operation module
Screws
(with drop-safe)
*1 : Installation of the MKS-8031ATB requires installa-
tion of the track ball after the module is installed in
steps 1 to 5.
Install the track ball by following the procedure
below.
6. Rotate the ball cover counter-clockwise to release the
lock.
7. Remove the ball cover and the track ball.
8. Rotate the ball cover clockwise until it is locked.
*2 : Install the MKS-8034ADK/8034AFB/8023AB/8042
in the following steps after performing steps 1 to 3.
4. Install the MKS-8042 to the right-most side of the
MKS-8076, and fix its left side with the supplied two
screws (PSW3 x 6), and its right side with the two
screws (with drop-safe).
PSW3 x 6
Ball cover
Track ball
MKS-8031ATB
Screws
(with drop-safe)
MKS-8042
MKS-8075A
2-5