Table of Contents
Advertisement
Installation
1. Remove the module covers on both sides of the
operation module that you want to remove or of the
blank panel.
2. Loosen the four screws (with drop-safe) fixing the
operation module or the blank panel.
3. Hold the two screws on the sides of the operation
module or the blank panel of both sides. Then remove
the operation module or the blank panel.
(When you want to install the MKS-8025MS, go to *1 .
Or you want to install the MKS-8042, go to *2 on next
page.)
4. Install the desired operation module to the position
where the operation module is removed in step 3.
Tighten the four screws (with drop-safe) and fix it.
5. Install the module cover.
(when you want to install the MKS-8031ATB, go to
*3 on next page.)
Module covers
Screws
Operation module
(with
drop-safe)
*1 : When installing an MKS-8025MS, and steps 1 to 3
described on the previous page have been completed,
connect the connectors by following the procedure
described below.
CCP-8000 IM
4. Connect the harness coming from the inside of the main
panel to the connector of the MKS-8025MS.
5. Install the MKS-8025MS and fix the four screws on
both sides.
6. Install the module covers.
n
The MKS-8025MS can be installed in the right end of
the top-most line of the panel. (Except when the MKS-
8042 comes to the right-most side)
Screws
(with drop-safe)
Screws
(with drop-safe)
Screws
MKS-8025MS
(with drop-safe)
When the MKS-8025MS comes to the right-most side
MKS-8025MS
MKS-8042
When the MKS-8042 comes to the right-most side
Module covers
Connector
Screws
(with drop-safe)
Module covers
Connector
Screws
(with drop-safe)
2-3
Hide quick links:
Advertisement
Table of Contents
