Assigning Receiving Operations To Keys; Adjusting In-Call Volume; Placing A Call On Hold When You Cannot Answer Call Immediately; On Hold>50 - Docomo LYNX SH-10B Instruction Manual

Any-key settings

Assigning receiving operations to keys

Assign the following keys to answer the call or stop the ring tone
temporarily when receiving a call.
1 to 9, 0, A to Z, -, /, ,,
Answer
., *, (, ), _ (space)
Keys other than H, +
Silent
1
In the main menu, [Settings]/[Call
[Any-key settings]
2
Select the setting
When you set to [Answer], you can operate in 1 second after receiving.
Adjust in-call volume

Adjusting in-call volume

1
During a call, adjust the volume with #/$
On hold
Placing a call on hold when you cannot
answer call immediately
The other party is charged for the call while on hold.
If subscribed to Voice Mail Service or Call Forwarding Service, a
received call is connected to the Voice Mail Service center or forwarded
to the set destination (nP. 240, P. 242).
1
During an incoming call, [Hold]
: The call is disconnected when you touch [Disconnect], press H or
when the other party disconnects the call.
2
[Answer] when ready to answer
50
Public mode (Power off)

Using Public mode (Power off)

Public mode (Power off) is an automatic answering service used
to ensure the manner in public places. Set Public mode (Power
off) to play a message for the caller stating that the power is off
and you are unable to speak (in a hospital, on the airplane, near
the priority seats on the train, etc.), and the call is disconnected.
Voice Mail Service
to Public mode (Power off).
Settings]/
* For voice calls whose ringing time is other than 0 seconds, the service
For calls from callers rejected by Nuisance Call Blocking Service, Public
mode (Power off) is not activated.
1
In the main menu, [Dialer]
2
Enter "b25251"
3
[Call]
: Public mode (Power off) is set (Nothing changes in the stand-by
: When a call is received while Public mode (Power off) is set and the
Disabling Public mode (Power off)
: In the main menu, [Dialer]/enter "b25250"/[Call]
Checking Public mode (Power off) setting
: In the main menu, [Dialer]/enter "b25259"/[Call]
■ When Public mode (Power off) is set
Public mode (Power off) remains set until disabled. The setting is not
canceled just by turning on the power. Public mode (Power off) message is
played when the handset is outside the service area or in a place with no
signal. When a call is received, a message stating that you are in a place
that does not allow the use of mobile phone is played and the call is
disconnected.
*
and Call Forwarding Service
is activated after the Public mode (Power off) guidance.
display).
handset is turned off, a message stating that you are currently in a
place that does not allow the use of mobile phone is played.
• Public mode (Power off) is disabled.
• Check the current setting.
*
are activated in priority