Installation For V.s2 With 8977/8978 Mortise Exit Device - Assa Abloy SARGENT Profile Series Installation Instructions Manual

Installation for Profie Series v.S2 With 8977/8978 Mortise Exit Device
8
1 - Prepare Door
A. Verify Hand and Bevel of Door
• Check handing of door - this device is
not reversible
• Door should be fitted and hung
• Verify box label for size of exit device,
function and handing
B. Door Preparation
Prep door using the following (available at www.intelligentopenings.com):
• Exit installation instructions A6705
• Field Template A7790
• Door Manufacturer's Template 4641 (Metal & Wood).
Note: Wood door has additional cutout if installation includes a cylinder.
2 - Install Mortise Lock
Slide mortise lock into door and securely fasten with (2) flat head screws (Fig. 2A).
3 - Position Exit Trim
1. For exterior applications, use ET gasket (52-0263) to seal
between ET escutcheon and outside door surface (Fig. 3A).
2. Route ET harness through square wire cutout and out
other side of door.
3. Place ET control on door with spindle inserted
through mortise lock (Fig. 3A).
Outside of Door
16 A7787F
Profile Series v.S2 WiFi With Mortise Exit Device
Fig. 2A
Inside
Left Hand
Reverse Bevel
Outside
LHRB
Fig. 1A
3
Fig. 3A
Showing Wood Door Template
2
Wood Door Template
With Cylinder
Right Hand
Reverse Bevel
RHRB
1
ET gasket
(part number
52-0263)
4
Outside of Door
Without Cylinder