Assa Abloy SARGENT Profile Series Installation Instructions Manual page 12

7 – Install Door Position Switch (DPS)
If it isn't installed, install the door position switch:
1. Prep door according to proper template (A7992).
2. Insert DPS into the raceway on the latch edge of the
door by |pushing wires down raceway towards the lock.
Note: Use collar ONLY when installing in a METAL door.
3. Push DPS firmly in place by hand.
Note: DO NOT TAP SWITCH WITH ANY TOOL.
4. Connect DPS to adapter that plugs into TB2.
Refer to diagrams in the wiring steps, beginning
with 9 – Connect and Position Outside Escutcheon Wires.
8 – Attach Gasket and Install Outside Escutcheon
For exterior applications, use a gasket (part number 82-0500)
between escutcheon and outside door surface.
To apply weatherseal gasket:
1. Carefully remove the backing from the gasket (Fig. 8A).
2A. For 12- fire rated devices:
ribbon cable/connector from outside of
door through gasket and fire stop plate (Fig. 8B).
2B. For non-12- exit devices:
ribbon cable/connector through the
gasket and then through the conduit
hole in door.
Note: Install ribbon cable with cable exiting down.
3. Apply gasket to escutcheon:
a. Starting in one place, press the
adhesive side of the gasket
firmly against the escutcheon.
b. Work around the escutcheon,
pressing the sticky side of the
gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so
that all edges of the escutcheon
are covered.
3. Place against the outside escutcheon,
while directing mounting posts
through the door.
12 A7787F
Profile Series v.S2 WiFi With Rim Exit Device
Feed keypad
Feed keypad
Fig. 7A
Gasket 82-0500
Fig. 8A
Fire
Stop
Plate
Keypad
Ribbon
Antenna
Ground
Harness
Weatherseal
Gasket
Fig. 8B