Assa Abloy SARGENT Profile Series Installation Instructions Manual page 23

Profile Series v.S2 WiFi With Mortise Exit Device
14 – Install (or Replace) Batteries
IMPORTANT: Do not install batteries if
controller is powered by external power supply.
1. To install the batteries, first remove the battery cover using
the security tool provided (Fig. 14A).
2. Unscrew the bottom screw of the battery keeper and
remove the battery keeper, being careful not to break the
tabs at top holding it in place. (Fig.14B)
3. Place (6) "AA" batteries in the compartment,
being careful to align polarity properly (Fig. 11C)
4. Replace battery keeper being careful to engage tabs at
top to hold it in place. (Fig. 14B)
5. Attach battery cover to inside escutcheon
making sure to line up tabs with retaining
slots in battery cover. Secure with the
security screw and tool. (Fig. 14A and 14D).
6. Three-pin connector from chassis connects to rail.
4
Fig. 14B
2
15 – Install Rail Assembly
Attach rail assembly according to Exit Installation Instructions A6770.
5
3
Fig. 14C
Fig. 14D
6
6
Fig. 14A
Tabs
5
A7787F
Battery
Cover
1
Security
Screw
Security Allen Wrench
01-0297
(Included)
Retaining
slots
23