Assa Abloy SARGENT Profile Series Installation Instructions Manual page 18

5 - Install Exit Chassis
1. Route ET harness through wire run channel for wood doors (Fig. 5A)
and through access hole for metal doors (not shown).
2. Mount exit chassis carefully. Do not pinch harness wires.
3. Position exit chassis on door with lever arm under
rear section of mortise lock (Fig. 5B).
4. Secure chassis and ET with (2) 1/4-20 x
2-3/8" flat head machine screws (Fig. 5C).
Fig. 5A
6 - Install Cylinder
For devices without cylinders, skip this section.
1. Verify orientation of cylinder (Fig. 6A).
2. Slide cylinder through ET trim and thread into the lockbody,
rotating the cylinder clockwise.
Cylinder should rest flush on ET case.
3. Tighten the cylinder clamp screw using
#2 Phillips screwdriver to prevent the
cylinder from unscrewing (Fig. 6B).
4. Test cylinder function:
For 77 Function, determine that the key retracts latch.
18 A7787F
Profile Series v.S2 WiFi With Mortise Exit Device
Ground
Latchbolt
Ring
Terminal
Unused
Correct Incorrect
Fig. 6A
(4) #10 Wood or
#10-24 Machine
Screws
Chassis
Inside of Door
Lever
Lever arm
Fig. 5B
Outside of Door
Fig. 6B
Fig. 5C
Cylinder
Clamp
Screw