Assa Abloy SARGENT Profile Series Installation Instructions Manual page 13

Profile Series v.S2 WiFi With Rim Exit Device
9 – Connect and Position Outside Escutcheon Wires
Images shown represent installation without gasket. If gasket is necessary, refer to 8 – Attach Gasket and Install
Outside Escutcheon.
Before the controller is attached to the door:
1. Attach the reader outside escutcheon reader assembly ribbon cable to the inside face of the controller as-
sembly (side that faces towards the door when mounted (P1).
iCLASS only
2. : Attach the antenna cable to the inside face of the controller assembly (P2).
3. Attach the ground harness to the bottom of the controller assembly (E1).
Outside Escutcheon
10 – Connect Ground Wire Harness
Attach the ground harness:
Outside of Door
1. Attach one leg of the ground harness to
bottom left screw of the controller assembly.
2. Attach the other leg of the ground harness to
the spade connector that was routed through
the top hole in the chassis in 3 – Secure Inside Trim
and Chassis, number 2.
3. There is an unused ground terminal
attached to the harness from the chassis.
Ground
Wire
Harness
3
1
Reader Cable
2
Antenna
(iCLASS)
Fig. 9A
1 Reader Cable
2
Antenna
(iCLASS
Only)
Unused
3
Ground
Wire
Harness
Fig. 5B
Inside of Door
Unused
3
2
Fig. 5B
P1
1
2
P2
E1
3
3
Reader Cable
Antenna
(iCLASS)
1
Ground Wire
Harness
Fig. 10A
A7787F 13