Assa Abloy SARGENT Profile Series Installation Instructions Manual page 10

3 – Secure Inside Trim and Chassis
1. Route ET harness through wire run channel for wood doors (Fig. 3A)
and through access hole for metal doors (not shown).
Note: Make sure no wires are pinched.
2. Before securing chassis, connect ground wire harness:
a. Spade connector of ground ring terminal wire fits
through the hole (beneath the top screw) in the
chassis and connects to lug on ground
harness (Fig. 3B Detail).
b. Route the ground ring terminal and secure
through the top center hole with the top
1/4-20 x 2-3/8" flat head machine
screw (Fig. 3B Detail).
3. Engage ET spindle in the hub of exit
device chassis.
4. Secure chassis and ET with (2) 1/4-20 x
2-3/8" flat head machine screws.
5. Connect ET harness and connector
from chassis (Fig. 3C).
Fig. 3B Detail
chassis, and out wire route slot
10 A7787F
2b
2a
Route wires under exits
Outside of Door
Profile Series v.S2 WiFi With Rim Exit Device
Ground
Ring
Terminal
Unused
5
Inside of Door
4
Ground Harness
Lug and Spade
Connector
1
3
Fig. 3A
4
Fig. 3C
Showing Wood Door Template
With Cylinder Hole
2
Ground
Ring
Terminal
(Unused)