Table Of Contents; Warning - Assa Abloy SARGENT Profile Series Installation Instructions Manual

Warning ...................................................................................2
1
General Description .................................................................3
2
Hardware Specifications .........................................................3
3
Electronic Specifications .........................................................3
4
Lock Wiring ..............................................................................4
5
Parts Breakdown .....................................................................5
6
Installation for v.S2 With 8877/8878 Rim Exit ........................9
7
Installation for v.S2 With 8977/8978 Mortise Exit Device ....16
8
Operational Check .................................................................24
9

Warning

1
FCC:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Industry Canada:
The term "IC:" before the radio certification number only signifies that Industry Canada technical specifications
were met.
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Cet appareillage numérique de la classe B répond à toutes les exigences de l'interférence canadienne causant des-
règlements d'équipement. L'opération est sujette aux deux conditions suivantes: (1) ce dispositif peut ne pas causer
l'interférence nocive, et (2) ce dispositif doit accepter n'importe quelle interférence reçue, y compris l'interférence qui
peut causer l'opération peu désirée.
To comply with "Fire Listed" doors, the batteries must be replaced with alkaline batteries only.
!
SARGENT Mfg. Co. v.S Series locksets utilizing a door position switch (DPS) are not rated for,
or intended for use in life safety applications.
1-800-810-WIRE • www.sargentlock.com • A7787F

Table of Contents

Changes or modifications to this unit not expressly approved by ASSA ABLOY Inc.
could void the user's authority to operate the equipment.