Assa Abloy SARGENT Profile Series Installation Instructions Manual page 20

9 – Install Gasket and Outside Escutcheon
For exterior applications, use a gasket (part number 82-0500)
between escutcheon and outside door surface.
To apply weatherseal gasket:
1. Carefully remove the backing from the gasket (Fig. 9A).
2A. For 12- fire rated devices:
connector from outside of door through gasket and fire
stop plate (Fig. 9B).
2B. For non-12- exit devices:
through the gasket and then through the conduit hole in
door (not shown).
Note: Install ribbon cable with side marked TOP facing up.
3. Apply gasket to escutcheon:
a. Starting in one place, press the
adhesive side of the gasket
firmly against the escutcheon.
b. Work around the escutcheon,
pressing the sticky side of the
gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so
that all edges of the escutcheon
are covered.
3. Place the outside escutcheon against,
while directing mounting posts
through the door.
20 A7787F
Profile Series v.S2 WiFi With Mortise Exit Device
Feed keypad ribbon cable/
Feed keypad ribbon cable/connector
Gasket 82-0500
Fig. 9A
Fire
Stop
Plate
Keypad
Ribbon
Antenna
Ground
Harness
Weatherseal
Gasket
Fig. 9B