Assa Abloy SARGENT Profile Series Installation Instructions Manual page 11

Profile Series v.S2 WiFi With Rim Exit Device
4 – Install Cylinder
For devices without cylinder, skip this step.
1. Insert cylinder into ET trim (Fig. 4A).
2. Mate cylinder tailpiece into hub of exit device chassis.
3. Make sure ET harness is clear of cylinder and cylinder tailpiece.
5 – Secure Chassis
1. Secure cylinder (if used) to exit chassis using
(2) #12-24 x 1-7/8" connecting screws (Fig 5A).
2. Fasten exit chassis to door using:
• (4) #10 wood screws
for wood doors (or)
• (4) #10-24 machine screws
for metal doors.
3. Position cylinder, if used,
so that the SARGENT logo
is right-side up (Fig. 5B).
6 – Door Options
A. Fire Stop Plate (P/N 52-0033)
Fire-rated doors require a fire stop plate on
Outside of Door
the outside of the door (Fig.6A).
1. If not present, drill (2) 1/8" x 1-1/4" deep
holes in the door.
Refer to template for fire-stop
prep locations.
2. Attach fire stop plate with flap up and out
using (2) #8 x 1/2" self-tapping screws
for wood and metal doors.
B. Weather Conduit (52-2847)
Install weather conduit on
exterior doors only (Fig. 6B).
1. Carefully insert the weather conduit into the
ribbon cable hole on the inside of the door.
2. Place the O-ring around the weather conduit
on the outside and up against the door (Fig. 6C)
Fig. 5A
NON FIRE-RATED
Outside of Door
Outside of Door
Fig. 4A
Unused
Correct Incorrect
(2) #12-24 x 1-7/8"
Inside of Door
(4) #10 Wood or
#10-24 Machine
Screws
Ribbon Cable Hole
Outside of Door
Fig. 6A
Fig. 5B
Fig. 6B
O-Ring
Fig. 6C
A7787F 11
Fig. 5