Assa Abloy SARGENT Profile Series Installation Instructions Manual page 22

12 – Additional Chassis Wiring Connections
Chassis, DPS and raceway wire connections:
1. Connect RX rail connector from ET
to chassis harness.
2. Attach connector from ET
to the controller assembly (TB1).
Tuck ferrite bead under circuit board.
3. Connect DPS from switch to 2-pin
connector of the harness connected
to controller assembly (TB2).
13 – Install Inside Escutcheon
1. Insert #8-32 x 1-1/4" screws through
inside escutcheon and thread into
outside escutcheon.
2. Tuck wires safely under space below
controller assembly.
3. Straighten escutcheons and tighten
securely (Fig. 13A).
22 A7787F
Profile Series v.S2 WiFi With Mortise Exit Device
3
Fig. 12A
2
1
Unused
Inside of Door
Fig. 13A
P1
P2
2
Ferrite
Bead
Unused
3
DPS
Inside of Door