Assa Abloy SARGENT Profile Series Installation Instructions Manual page 21

Profile Series v.S2 WiFi With Mortise Exit Device
10 – Connect and Position Outside Escutcheon Wires
Images shown represent installation without gasket. If gasket is necessary, refer to 9 – Install Gasket and Outside
Escutcheon.
Before the controller is attached to the door:
1. Attach the reader assembly ribbon cable to the inside face of the controller assembly (the side that faces
towards the door when mounted) - P1.
iCLASS only
2. : Attach the antenna cable to the inside face of the controller assembly (P2).
3. Attach the ground harness to the bottom of the controller assembly - E1.
Outside Escutcheon
11 – Connect Ground Wire Harness
Outside of Door
Attach the ground harness:
1. Attach one leg of the ground harness to bottom left
screw of the controller assembly. (Fig. 11A).
2. Attach the other leg of the ground harness to
the spade connector that was routed through
the top hole in the chassis in 4 – Secure Inside Trim
and Chassis.
3. There is an unused ground terminal
attached to the harness from the chassis.
Ground
Wire
Harness
3
1
Reader Cable
2
Antenna
(iCLASS)
Fig. 10A
Reader Cable
1
2
Antenna
(iCLASS
Only)
Ground
Wire
Harness
Fig. 5B
Inside of Door
Unused
3
2
Fig. 5B
P1
1
2
P2
E1
3
3
Reader Cable
Antenna
(iCLASS Only)
1
Ground Wire
Harness
Fig. 11A
A7787F 21