Assa Abloy SARGENT Profile Series Installation Instructions Manual page 14

11 – Connect and Position Chassis Wires
1. Connect RX rail connector from ET
to chassis harness.
2. Attach connector from ET
to the controller assembly (TB1).
Tuck ferrite bead under circuit board.
3. Connect DPS from switch to 2-pin
connector of the harness connected
to controller assembly (TB2).
12 – Install Inside Escutcheon
1. Insert #8-32 x 1-1/4" screws through
inside escutcheon and thread into
outside escutcheon.
Make sure the top screw routes through
the ground ring terminal.
2. Tuck wires safely under space below
controller assembly.
3. Straighten escutcheons and tighten
securely (Fig. 12A).
14 A7787F
Profile Series v.S2 WiFi With Rim Exit Device
3
Fig. 11A
2
1
Unused
Inside of Door
Fig. 12A
P1
P2
2
TB1
Ferrite
Bead
Unused
3
DPS
Inside of Door