Restore The Configuration - Oracle Sun Blade 6000 Product Notes

Restore the Configuration

Note -
slash) symbols.
2. Ensure that you have proper login credentials for the server where the
configuration is to be backed up.
Back up the configuration to remote server.
3.
set dump_uri=ftp://username:password@192.168.1.100/tmp/myNEMconfig.bak
->
Dump successful
Restore the Configuration
Note -
or restore operation. Because of CR 6934622, the SNMP engine ID (even when previously
set) is not visible after a reset of the system, and the administrator must record and set the ID
explicitly.
Configure the network settings on the Oracle ILOM network management
1.
interface to communicate with the backup server.
cd /SP/network
->
2. Set the passphrase to the same value that was used for backup.
See "Include the SEFOS Configuration in Backups" on page
cd /SP/config
->
/SP/config
-> set passphrase=abc123
Set 'passphrase' to 'abc123'
3. Restore the configuration from the server.
set load_uri=ftp://username:password@192.168.1.100/tmp/myNEMconfig.bak
->
Load successful.
Note -
supplied by the DHCP server upon restoration.
28 Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Release 1.2.2 Product Notes • March 2016
The passphrase you provide must not contain the @, ' (apostrophe), " (quotes), or \ (back
The administrator must always reset the SNMP engine ID prior to doing the backup
If DHCP is used for network configuration, the DNS setting is overwritten with values
27.