Oracle Sun Blade 6000 Product Notes page 22

Upgrade the NEM Firmware
NOTE: An upgrade takes about 6 minutes to complete. ILOM will
enter a special mode to load new firmware. No other tasks
can be performed in ILOM until the firmware upgrade is
complete and ILOM is reset.
Are you sure you want to load the specified file (y/n)?
Preserve existing configuration (y/n)?
Starting FW upgrade. This will take approximately 3 minutes.
Checking "jffs2 root file system image"
Starting Root File System upgrade
Upgrading Root File System image to partition 2
................................................................
................................................................
................................................................
................................................................
Validating File System and updating Time Stamp.
This will take 2-3 minutes, please wait.
Checking "compressed kernel image"
Starting kernel upgrade
Upgrading kernel image to partition 2
.......
Syncing configuration files.
....................................
Checking "FPGA image"
Starting FPGA upgrade
Skip upgrading FPGA (same version).
Checking "U-Boot image"
Starting U-Boot upgrade
Skip upgrading U-Boot (same version).
Firmware update is complete.
The system must be reset for the new image to be loaded
reset /SP
->
Are you sure you want to reset /SP (y/n)?
Performing reset on /SP
If the upgrade was done while in ONET mode, you must explicitly restart ONET from Oracle
ILOM after the upgrade as follows:
start /NEM/onet
->
Are you sure you want to start /NEM/onet (y/n)? y start:
start: Please wait while onet comes up, this can take
anywhere from 30 seconds to 2 minutes depending on the
configuration
........................
start: ONET Enabled successfully.
22 Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Release 1.2.2 Product Notes • March 2016
y
y
y