Table of Contents
Advertisement
show
start
stop
Note -
See
"CMM Reports SAS2 on the NEM as Faulty if SAS2 Is Not Enabled
(6977266)" on page 38
you are not enabling the SAS2 functionality.
Configure 1Gbps Mode on SFP+ Interfaces
The two SFP+ ports, 1 and 2 are dual-speed capable ports and can provide 1Gbps connectivity
when used with the supported transceivers and configured for 1Gbps operation from the SEFOS
CLI.
To configure a 1G-MMF link, use the supported 10G/1G SFP+ transceiver (PN x2129a).
■
The speed must be changed to 1G on the appropriate port (see example below).
To configure a 1G-Cu (RJ45) link, use the supported SFP transceiver (PN x2123a), which
■
provides a RJ45 interface. This is a 1G-only transceiver and the speed must be changed to
1G on the appropriate port (see the following example).
When using 1Gbps mode, autonegotiation must be disabled on the link-partner. The
Caution -
link-partner must be configured in 1Gbps-Forced-FDX mode.
1.
Obtain the SEFOS prompt.
Type these commands to configure the speed to 1G.
2.
For example, to configure ports 1 and 2.
config terminal
SEFOS#
SEFOS(config)#
SEFOS(config-if)#
SEFOS(config-if)#
SEFOS(config-if)#
SEFOS(config-if)#
SEFOS#
write startup-config
Fine Tune the VLAN Setup
The NEM provides flexibility in managing ingress VLAN traffic. For example, you can set port
ingress filtering to enabled and can also specify the acceptable frame type to implement fine-
grained control on the ingress traffic. Refer to the Sun Ethernet Fabric Operating System CLI
Base Reference Manual for details.
for important information about upgrading the NEM firmware if
interface range extreme-ethernet 0/1-2
shutdown
speed 1000
no shutdown
end
Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Release 1.2.2 Product Notes
Configure 1Gbps Mode on SFP+ Interfaces
25
Advertisement
Table of Contents
