Table of Contents
Advertisement
5.
When the NEM reboots after the upgrade, type the version command to verify
that software version is upgraded.
6.
To show the system information, type these commands.
cd /NEM/fs_cli/
->
cd: Connecting to Fabric Switch CLI
ORACLESP-0110SJC-0938CB0081 SEFOS#
Hardware Version
Firmware Version
Switch Name
System Contact
System Location
Logging Option
Login Authentication Mode
Config Save Status
Remote Save Status
Config Restore Status
Enable or Disable SAS2 From Oracle ILOM
By default SAS2 links are disabled on the SAS2 expander firmware for the NEM. To enable
SAS2 links and to allow server modules with supported REMs to communicate with the Sun
Blade Storage Module M2, you must enable SAS2 from Oracle ILOM.
If you enabled SAS2 during a prior release, it stays enabled during and after the upgrade,
Note -
and no other steps are required. When SAS2 is disabled, the fru_extra_1 field shows SAS
5.3.2.0 in the output of the show /CH/NEMx command (where x is the NEM's slot number)
from the CMM level. When SAS2 is enabled, the fru_extra_1 field shows SAS 5.3.7.0 in
the output of the show /CH/NEMx command (where x is the NEM's slot number) from the CMM
level.
1.
Display the current SAS2 status.
->
cd /NEM/SAS/
/NEM/SAS
ls
/NEM/SAS->
Targets:
Properties:
type = SAS Expander
sas_status = disabled
Commands:
cd
show system information
: 2.5.8_00209384
: ONEM-
: C10 NEM 24P
:
:
: Console Logging
: Local
: Not Initiated
: Not Initiated
: Not Initiated
Sun Blade 6000 Ethernet Switched NEM 24p 10GbE Release 1.2.2 Product Notes
Enable or Disable SAS2 From Oracle ILOM
23
Advertisement
Table of Contents
