Figure 3-18: Installing The 5881Enhc With Tamper Protection - Honeywell VISTA-128BPEN Installation And Setup Manual

Vista-128BPEN Installation and Setup Guide
A response type (05 Day/Night) must be programmed for zones 990 (1
U L
installations.
•
The 5881ENHC receiver contains front and back tampers that permit its use in commercial burglary installations.
•
You may only mount the 5881ENHC its own plastic housing. Otherwise, the receiver constantly reports a tamper
condition.
•
The control checks the receiver connections about every 45 seconds. The receiver supervisory zone is 8 + 2-digit
receiver device address (for example, Device address 05 = supervisory zone 805).
NOTE: This zone must be programmed with a response type (e.g., type 05 Day/Night Trouble) before it supervise
the connection to the receiver.
•
Use two identical receivers to provide either a greater area of coverage or redundant protection. They must be set for
different addresses.
NOTE: No more than two receivers can be installed.
•
Any zone from 1 to 128 can be used as a 5800 Series wireless zone, with the exception of zone 64 (reserved for a
wireless keypad).
RF System Installation Advisories
•
Place the receiver in a high, centrally located area. Do not place it on or near metal objects. This will decrease the
range and/or block transmissions.
•
Install the RF receiver at least 10 feet from the control panel or any keypads, to avoid interference from the
microprocessors in these units.
•
If dual receivers are used:
a. They must be at least 10 feet from each other, as well as from the control panel and remote keypads.
b. Each receiver must be set to a different device address. The receiver set to the lower address is considered the
st
1 RF receiver for supervisory purposes.
c. The House IDs must be the same.
d. Using two receivers does not increase the number of transmitters the system can support (127 zones using the
5881H, plus a wireless keypad).
Installation and Setup of 5881 RF Receivers
Take note of the address you select for the RF receiver, as this address must be enabled in the system's Device
Programming in the #93 Menu Mode .
3-14

Figure 3-18: Installing the 5881ENHC with Tamper Protection

st
receiver) and 988 (2
SCREW
5881ENHC-001-V0
nd
receiver) for UL