Figure 3-17: Installing The 5881Enhc With Tamper Protection; Figure 3-18: 5881Enhc Rf Receiver (Cover Removed) - Honeywell VISTA-128BPT Installation And Setup Manual

Installation and Setup of 5881ENHC RF Receivers
Take note of the address you select for the RF receiver, as this address must be enabled in the system's Device
Programming in the #93 Menu Mode.
To install the 5881ENHC RF receiver, perform the following steps:
Step Action
1 Mount the receiver, following the advisories stated previously.
2 Set the DIP switches in the receiver for the address (01-07). See Figure 3-18.
Make sure the address setting is not being used by another device (keypad, relay module, etc.).
3 If installing a 5881ENHC, install a flat-head screw (supplied) in the case tamper tab as shown in Figure 3-17.
When the receiver is pried from the wall, the tamper tab will break off and remain on the wall. This will
activate a tamper switch in the receiver and cause generation of a tamper signal. Note that this signal will
also be generated when the receiver's front cover is removed.
4 Connect the receiver's wire harness to the keypad terminals (6, 7, 8, and 9). Plug the connector at the other
end of the harness into the receiver.
5 Refer to the Installation Instructions provided with the receiver for installations regarding antenna
mounting, etc.
CIRCUIT
BOARD
MOUNTING
HOLES

Figure 3-17: Installing the 5881ENHC with Tamper Protection

ANTENNAS
INSERT IN
RIGHT-HAND
TERMINALS
DIP SWITCH INTERFERENCE
INDICATOR LED

Figure 3-18: 5881ENHC RF Receiver (cover removed)

SCREW
5881ENHC-001-V0
TO CONTROL'S REMOTE KEYPAD
CONNECTION POINTS.
USE MAX. of 220 ft. [67m of #22 (0.64mm)
WIRE or 550 ft. (168m) of #18 (1mm) WIRE
FOR EACH RUN. OBSERVE 20 ft. MAX.
YELLOW
DIP SWITCH WHITE AREAS = SWITCH
RED
HANDLES. POSITION 2-4 DETERMINE
BLACK
RECEIVER'S ADDRESS. CONSULT
CONTROL'S INSTRUCTIONS FOR
GREEN
ADDRESS TO USE. DIP SWITCH BELOW
SHOWN SET FOR ADDRESS "0."
WIRING
SWITCH
OPENING
POSITION
PLUG & SOCKET
Section 3 – Installing the Control
RECEIVER ADDRESS SETTINGS
(" - " MEANS OFF)
0 1 2 3 4 5 6 7
PRESET TO OFF
5
ON ON ON ON
4
ON ON ON ON
3
ON ON ON ON
2
1
FOR FUTURE USE
5881-001-V3
3-15