Honeywell VISTA-128BPEN Installation And Setup Manual page 81

FIELD TITLE and DATA ENTRIES
Allow Disarm Outside Window if
2*11
Alarm Occurs
0 = disable
1 = enable
Enable GOTO for this Partition
2*18
(partition-specific)
0 = disable
1 = enable
Use Partition Descriptor
2*19
0 = disable
1 = enable
Enable J7 Triggers for Partition
2*20
(partition-specific)
0 = disable
1 = enable
Supervision Pulses for LRR
2*21
0 = disable
1 = enable
Display Fire Alarms of Other
2*22
Partitions (partition-specific)
0 = disable
1 = enable
Display Burg, Panic and CO
2*23
Alarms for Other Partitions
(partition-specific)
0 = disable
1 = enable
Display Troubles of Other
2*24
Partitions (partition-specific)
0 = disable
1 = enable
EXPLANATION
If enabled, allows the system to be disarmed outside the programmed disarm
(opening) window if an alarm has occurred. Otherwise disarming is allowed
only during the disarm window.
NOTE: Used only if field 2*10 is enabled.
If enabled, this partition can be accessed from another partition's keypad
using the GOTO command.
If enabled, the normal keypad display will include a partition number and four-
digit descriptor.
If enabled, the J7 triggers function for this partition.
There are three entries in this field as follows: Fire, Burglary/Audible Panic
and Silent Panic/Duress.
If enabled, causes the control to send periodic short pulses on the J7 radio
triggers to the LRR. The LRR uses these pulses to determine that its
connection to the control is still intact.
Must be 1 for UL installations.
If enabled, allows fire alarms that occur on other partitions to be displayed at
this partition's keypad(s).
If enabled, allows burglary, panic and CO alarms that occur on other partitions
to be displayed at this partition's keypad(s).
If enabled, allows troubles that occur on other partitions to be displayed at this
partition's keypad(s).
Section 5 – Data Field Descriptions
5-13