Installing The Audio Alarm Verification Module; Figure 3-33: Vip Module Connections - Honeywell VISTA-128BPEN Installation And Setup Manual

Commercial burglary partitioned security system with scheduling
Table of Contents

Advertisement

Vista-128BPEN Installation and Setup Guide
• If touch-tones are not present following phone access to the security system via an on-premises phone , try
reversing the pair of wires connected to terminals 3 and 4 on the 4286.
• If the phone plug is disconnected from the control, the premise's phones will not operate.
SPEAKER NOTE: IF CONNECTING SINGLE SPEAKER, USE 8-ohm SPEAKER ONLY.
4286 VIP MODULE
NOTE:
4286 DEVICE
ADDRESS IS
FACTORY SET
TO "4"
YELLOW
GREEN
4500
THERMOSTAT
IMPORTANT NOTE FOR EXISTING INSTALLATIONS:
EXISTING WIRES CONNECTED TO THE "HANDSET"
TERMINALS ON CONTROL MUST BE MOVED FROM
THERE TO TERMINALS 3 AND 4 ON THE 4286.

Installing the Audio Alarm Verification Module

U L
Audio Alarm Verification (AAV) is not permitted in UL installations.
Contact ID code for "Listen-in to Follow" is 606. Contact ID is the only reporting format that will send a "Listen-in
to Follow." It is the only format capable of uniquely reporting all 128 zones, as well as openings and closings for
all 150 users. This requires central stations to be equipped with the MX8000 receiver to fully support all new
VISTA-128BPEN report codes. If you need to update your MX8000 receiver, contact your distributor.
If you are also using a 4286 VIP Module, be sure to follow Figure 3-34 when making connections.
The UVS consists of a UVCM and at least one UVST. The UVCM board has a DC power jack and a 34-position terminal
block for making connections to a DC power source, UVSTs, telephone lines, music source, or to the 4286 VIP Module;
and to a control panel's voice trigger and bell outputs (if required). Refer Figure 3-34 for wiring connections. For a
detailed explanation of the wiring connections and the functions of the DC power jack and terminal block positions, refer
to the installation instructions that accompany the UVS.
3-30
IF CONNECTING 2 SPEAKERS, USE 4-ohm or 8-ohm SPEAKERS
AND CONNECT IN SERIES.
SPEAKER
VOLUME
CONTROL
NO
CONNECTION
KEYED
HEADER
TO CONTROL PANEL
KEYPAD CONNECTIONS
YELLOW
NO CONNECTION
RED
BLACK
GREEN
U.S. PATENT No. 4791658

Figure 3-33: VIP Module Connections

SEE SPEAKER NOTE
GREY
BROWN
EARTH
GROUND
TIP RING TIP RING
HANDSET INCOMING
TELCO LINE
THIS DEVICE COMPLIES WITH FCC RULES, PART 68
FCC REGISTRATION No. AC3USA-74659-KX-N
RINGER EQUIVALENCE: 1.0B
FOR COMPLETE INFORMATION, SEE INSTALLATION
INSTRUCTIONS N6431-3 ACCOMPANYING 4286 VIP
MODULE
INCOMING TELCO LINE
TIP
RJ31X
RING
PREMISES
JACK
ANSWERING
MACHINE AND
CALLER ID
PHONES
UNIT
ANSWERING
MACHINE
4286_wiring-002-V1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents