Honeywell VISTA-128BPEN Installation And Setup Manual page 61

MAIN MENU
ZONE PROG?
1 = YES 0 = NO 0
EXPERT MODE?
1 = YES 0 = NO 0
REPORT CODE PROG?
1 = YES 0 = NO 0
ALPHA PROG?
1 = YES 0 = NO 0
DEVICE PROG?
1 = YES 0 = NO 0
OUTPUT PGM?
1 = YES 0 = NO 0
RLY VOICE DESCR?
1 = YES 0 = NO 0
CUSTOM INDEX ?
1 = YES 0 = NO 0
ACCESS POINT PGM
1 = YES 0 = NO 0
ACCESS GRP PGM
1 = YES 0 = NO 0
EVENT/ACTION PGM
1 = YES 0 = NO 0
SCHEDULED CHK-IN
1 = YES 0 = NO 0
OPTIONS
For programming the following:
•
Zone Number
•
Zone Response Type
•
Partition Number for Zone
•
Dialer report code for zone
Same as Zone Programming except:
•
Done with a minimum number of keystrokes.
•
Can program wireless keys using pre-defined templates.
For programming the following:
•
Alarm report codes for zones
•
Restore and supervisory codes
•
All other system report codes
For entering alpha descriptors for the following:
•
Zone Descriptors
•
Installer's Message
•
Custom Words
For defining the following device characteristics for addressable devices, including keypads, RF receivers
(5881), output relay modules (4204/4204CF), FSA (FSA-8/FSA-24), 4286 VIP Module, Panel Link Module
(VA8201), ECP communicator (7845GSM, 7845i-GSM), and VISTA Gateway Module:
•
Device Address
•
Device Type
•
Keypad Options (including Partition assignment)
•
RF House ID
•
LRR Options (including Programming radio)
For defining output device functions.
For entering voice descriptors for relays to be used with the 4286 VIP Module.
For creating custom word substitutes for VIP Module annunciation.
For defining the parameters for each of the VistaKey zones, including which group(s) have access through
an access point (door). See the VistaKey-SK Installation and Setup Guide for detailed programming
instructions.
For defining the capabilities (privileges) for each group of users. See the VistaKey-SK Installation and Setup
Guide for detailed programming instructions.
For defining events and time windows for an access group. See the VistaKey-SK Installation and Setup
Guide for detailed programming instructions.
For defining the schedule for the system to automatically call the downloader.
•
Input Device Type for zone (whether RF, polling
loop, etc.)
•
Enrolling serial numbers of 5800 Series transmitters
& serial polling loop devices into the system.
•
Zone Attributes (e.g., Arm w/Fault, Silent, etc.).
•
Partition Descriptors
•
Relay Descriptors
4-3