Wireless Zone Expansion; Figure 3-19: Installing The 5881Enhc With Tamper Protection - Honeywell ADEMCO VISTA-40 Installation And Setup Manual

Wireless Zone Expansion

The 5881ENHC RF Receiver and the 5869 Holdup
U L
Switch Transmitter are listed for UL Commercial
Burglary applications. All other RF receivers and
transmitters are not listed for UL Commercial
Burglary applications.
The following table lists the receivers that may be used
and the number of zones they support.
5800 Series Receivers
Receiver
5881L
5881M
5881H
In Canada, 5800 systems must use 5882 Series
receivers: 5882L/5882H. Information to the 5881
Receivers applies as well to the 5882 Receivers.
Both receivers use the same transmitters.
RF System Operation and Supervision
The 5800 RF system operation has the following
characteristics:
•
The receiver responds to a frequency of 345MHz.
•
The receiver has a nominal range of 200 feet.
•
Supervised transmitters send a supervisory signal
every 70-90 minutes.
•
Zones 88 and 90 are used to supervise the RF
reception of receivers 2 and 1, respectively. The
reception is supervised for two conditions:
1. The receiver goes "deaf" (doesn't hear from any
transmitter) within a programmed interval of
time (defined by program field 1*30).
2. Proper RF reception is impeded (i.e., jamming
or other RF interference). The control checks
for this condition every 45 seconds.
A response type (05 Day/Night) must be
U L
programmed for zones 90 (1
nd
(2 receiver) for UL installations.
•
The 5881ENHC receiver contains front and back
tampers that permit its use in commercial burglary
installations.
•
You may only mount the 5881ENHC its own plastic
housing. Otherwise, the receiver constantly reports
a tamper condition.
•
The control checks the receiver connections about
every 45 seconds. The receiver supervisory zone is
89 and 91 for receivers 2 and 1, respectively.
NOTE: These zones must be programmed with a
response type (e.g., type 05 Day/Night Trouble)
before they supervise the connection to the receiver.
Zones
up to 8
up to 16
up to 64
st
receiver) and 88
Section 3 - Installing the Control
•
Use two identical receivers to provide either a
greater area of coverage or redundant protection.
They must be set for different addresses.
•
Any zone from 1 to 64 can be used as a 5800 Series
wireless zone, with the exception of zone 64
(reserved for a wireless keypad).
RF System Installation Advisories
•
Place the receiver in a high, centrally located area.
Do not place it on or near metal objects. This will
decrease the range and/or block transmissions.
•
Install the RF receiver at least 10 feet from the
control panel or any keypads, to avoid interference
from the microprocessors in these units.
•
If dual receivers are used:
a. They must be at least 10 feet from each other,
as well as from the control panel and remote
keypads.
b. Each receiver must be set to a different device
address. The receiver set to the lower address
is considered the 1
purposes.
c. The House IDs must be the same.
d. Using two receivers does not increase the
number of transmitters the system can support
(63 zones using the 5881H, plus a wireless
keypad).
Installation and Setup of the 5881 RF Receivers
Take note of the address you select for the RF
receiver, as this address must be enabled in
the system's Device Programming in the #93
Menu Mode.
Figure 3-19: Installing the 5881ENHC with Tamper
Protection
st
RF receiver for supervisory
SCREW
5881ENHC-001-V0
3-13