Figure 8: Installing The 5881Enhc With Tamper Protection - Honeywell VISTA-128BPT Installation And Setup Manual

VISTA-128BPT/128BPT-SIA/250BPT INSTALLATION AND SETUP GUIDE
• The control checks the receiver connections
about every 45 seconds. The receiver supervisory
zone is 8 + 2-digit receiver device address (for
example, Device address 05 = supervisory zone
805).
NOTE: This zone must be programmed with a
response type (e.g., type 05 Day/Night
Trouble) before it supervise the
connection to the receiver.
• Use two identical receivers to provide either a
greater area of coverage or redundant protection.
They must be set for different addresses.
RF System Installation Advisories
UL
The 5827 and 5804BD are not UL Listed and are not intended for use in UL Listed applications.
•
Place the receiver in a high, centrally located
area. Do not place it on or near metal objects.
This will decrease the range and/or block
transmissions.
•
Install the RF receiver at least 10 feet from the
control or any keypads, to avoid interference
from the microprocessors in these units.
•
If dual receivers are used:
a. They must be at least 10 feet from each
other, as well as from the control panel and
remote keypads.
Receiver Installation
5881ENHC High Wireless Receiver
Take note of the address you select for the RF receiver, as this address must be enabled in the system's
Device Programming in the #93 Menu Mode.
1. Mount the receiver, following the advisories stated previously.
2. Set the DIP switches in the receiver for the address (01-07). See Figure 9.
Make sure the address setting is not being used by another device (keypad,
relay module, etc.).
3. If installing a 5881ENHC, install a flat-head screw (supplied) in the case
tamper tab as shown in Figure 8. When the receiver is pried from the wall, the
tamper tab will break off and remain on the wall. This will activate a tamper
switch in the receiver and cause generation of a tamper signal.
NOTE: This signal will also be generated when the receiver's front cover is
removed.
4. Connect the receiver's wire harness to the keypad terminals (6, 7, 8, and 9).
Plug the connector at the other end of the harness into the receiver.
5. Refer to the Installation Instructions provided with the receiver for
installations regarding antenna mounting, commercial settings, etc.
NOTES:
• No more than two receivers can be installed.
• If the receivers installed do not contain the same
wireless transmitter capacity (see table above),
the panel will only support a total number of
zones corresponding to the receiver with the
lowest transmitter capacity.
• Any zone from 1 to 250 can be used as a 5800
Series wireless zone, with the exception of zone
64 (reserved for a wireless keypad supervision)
b. Each receiver must be set to a different
device address. The receiver set to the
lower address is considered the 1
receiver for supervisory purposes.
c. The House IDs must be the same.
d. Using two receivers does not increase the
number of transmitters the system can
support (249 zones using the 5881ENHC,
plus a wireless keypad).
4-6
st RF
Figure 8: Installing the
5881ENHC with Tamper
Protection