Connectors; Table 3-2 Baseboard Connectors - SMART Embedded Computing MVME7100ET Installation And Use Manual

Controls, LEDs, and Connectors
3.3.3

Connectors

This section describes the pin assignments and signals for the connectors on the
MVME7100ET. The table below lists the standard connectors on the MVME7100ET
baseboard. Refer to
connectors are in the following sections. Some connectors use standard pin assignments
in compliance with the VMEbus, IEEE, PCI, and ANSI/VITA specifications. Links to these
specifications are located at
Table 3-2
Reference
Designator
J6
J4A
J4B
J11, J12, J13, J14
J21, J22, J23
J1
P1
P2
P4
P5
50
Figure 3-1 on page 47
Chapter B, Related Documentation on page
Baseboard Connectors
Function
XMC Expansion
TSEC 1, 10/100/1000 Ethernet RJ-45
TSEC 2, 10/100/1000 Ethernet RJ-45
PMC1
PMC2
Port 0. Serial Port 1
VME five-row P1
VME five-row P2 on SBC and
RTM
Processor COP header
Boundary Scan header
MVME7100ET Single Board Computer Installation and Use (6806800K87G)
Controls, LEDs, and Connectors
for connector locations. Pin assignments for the
Notes
8X PCI-E to XMCSpan
Implementing all recommended and
optional VITA32 signals except
RESETOUT#
Mini DB-9 console serial port
TSEC3 signals assigned to E1-1 thru E1-4
TSEC4 signals assigned to E2-1 thru E2-4
Serial ports 2-5
109.