Replacing Light Bulbs - Valor LX1 Installation Manual

Installation
Lighting
This appliance is equipped with decorative lighting
located above the fuel bed.
Test this overhead lighting before completing installation
(see "Appendix B - Remote Control Operation" on page
65). If any of the bulbs are out, replace them using the
following steps.
Required Bulbs
The light bulbs in the LX1 are 120V, 20W bi-pin (JC)
halogen bulbs GY6.35. A total of 4 are installed in the
unit.
Remove Barriers and Windows
Changing the light bulbs requires access to the inner
fi rebox. See "Remove the Windows" on page 26 for
details on removing the windows from the fi replace.
It is easiest to see and change the light
bulbs opposite the window you are
opening. You may find it easier to remove
both front windows if bulbs on both side of the
appliance need changing.
Change Bulbs
Wear gloves when changing these bulbs.
Most manufacturers recommend never
touching them as oil from your skin can
shorten their life.
1. Gently pull the bulb out of the receptacle in the
lighting track.
2. Replace with a new bulb. Be careful to align pins with
the receptacle holes.
3. Test the lighting with the handset before replacing
windows (lighting can operate independent of main
fi re being on or off ).
4. Reinstall windows.

Replacing Light Bulbs

47