Checking Pilot And Burner Flames; Replacing Light Bulb; Using Handset Wall Holder; Replacing Batteries - Valor Ventana 1200EAN Installation & Owner's Manual

OWNER'S
INFORMATION
opening (b).

Checking Pilot and Burner Flames

A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
Correct Flame Picture
Pilot Flame can be seen between logs
of installation and climatic conditions.
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.

Replacing Light Bulb

The appliance is equipped with a decora-
tive light inside the fi rebox located in front
of the window. To replace the light bulb,
follow these steps:
1. Turn off the decorative light wall switch.
2. Locate the light fi xture. Loosen the screws of the
Tab
Light fi xture with glass cover
8
Owner's Information
Thermocouple
Probe must be in
Pilot Flame
Flame
Tab
glass cover retaining tabs.
3. While holding the glass cover so it does not fall and
shatter, swivel one or both of its retaining tabs to
Light fi xture without glass cover
free the glass. Gently remove the glass cover.
4. Remove the light bulb from its socket by pushing
towards one end.
5. With a gloved hand, replace with a new light bulb
using only a 100 watts halogen 130 volts (type J
100W Halogen Light Bulb (119mm)
T3, 119 mm long).
6. Test the bulb by turning the wall switch on. Turn
the switch off again to complete the operation.
NOTE: If the bulb is new and not functioning, turn
off the dimmer switch and call your local electrician
for inspection.
7. Put the glass cover back in place and, while
holding it, turn the retaining tab(s) to retain
the glass.
8. Tighten the tabs' screws.

Using Handset Wall Holder

Your fi replace equipment includes a wall
holder to store the handset. If it hasn't be
installed, refer to the instructions further
on in this manual for the installation.
WARNING
!
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT! Let
the fi replace cool fi rst before touching it.
CAUTION
DO NOT USE a screwdriver or other metallic
object to remove the batteries from the receiver or
the handset! This could cause a short circuit to the
receiver.

Replacing Batteries

Low battery signal: see page 15.
BEFORE changing the batteries, turn off the valve