Replacing Light Bulbs - Valor LX2 Series Installation & Owner's Manual

Replacing Light Bulbs

Overhead Lighting (3 light bulbs)
The appliance is equipped with a decorative lighting
located above the fuel bed. To replace the light bulbs,
follow these steps:
1. Remove the front glass window.
2. Locate the light fi xture above the fi rebed.
3. Turn off the lighting using the remote control handset.
4. Remove the burned light bulbs from their sockets
by gently pulling on them sideways.
5. With a gloved hand, replace with new light bulbs
using only a 20 watts halogen 120 volts
(type GY6.35 base bi-pin).
6. Test the bulbs by turning the lighting on.
NOTE: If the bulbs are new and not functioning,
turn off the remote control lighting and call your
dealer for inspection.
7. Reinstall the front window.
MAINTAINING YOUR FIREPLACE
Underbed lighting (14 light bulbs) (if used)
If the 2200ULK—Underbed Lighting Kit has been
installed, you can replace the burned light bulbs in the
following manner.
1. Remove the front glass window.
2. Remove the fuel bed.
3. Remove the media trays, front and back (3 screws
each).
4. Locate the light fi xture below the fi rebed.
5. Turn off the underbed lighting using the wall dimmer
switch.
6. Remove the burned light bulbs from their sockets
by gently pulling on them towards the center.
7. With a gloved hand, replace with new light bulbs
using only a 20 watts halogen 120 volts
(type GY6.35 base bi-pin).
8. Test the bulbs by turning the lighting on.
NOTE: If the bulbs are new and not functioning,
turn off the dimmer switch and call your dealer for
inspection.
9. Replace the media front and rear trays.
10. Reinstall the fuel bed—see the instructions to
install the fuel beds in this manual.
11. Refi t the window.
OWNER'S
INFORMATION
23