Installing Driftwood Kit 2100Dwk - Valor LX1 Installation Manual

Installation

Installing Driftwood Kit 2100DWK

Material required
• Driftwood Log Kit, which contains:
• 5 logs
• 7 pebbles
• 1 x 5.5 cup bag of vermiculite (not pictured)
• Gloves, if desired
2965
2967
Log placement on media tray and burner. Black dots indicate
holes for pin placement.
Installation
Carefully unpack the kit. Note some logs have pins and
holes to help you place them on the burner platform, or
other logs.
Install the kit as follows.
40
2966
3720
2939
1. Place the vermiculite onto the burner by hand (avoid
pouring as this can deposit fi ne dust in the burner
ports). Be careful not to overfi ll and block any burner
ports. (You should hold back at least half of the bag)
2. Do not place more than a couple of pieces of vermicu-
lite in the pilot light's safe zone.
3. Place log 2966 using the two pinholes indicated.
Fuel Beds