Installing Rock And Shale Set 2100Rss - Valor LX1 Installation Manual

Installation

Installing Rock and Shale Set 2100RSS

Material required
• Rock and Shale Set, which contains:
• 4 logs
• 24 rocks
• 2 bags of light and dark embers (not pictured)
• Gloves, if desired
Installation
Carefully unpack the kit. Install the set as follows.
1. Mix together the 2 bags of light and dark embers.
2. Place the mixed embers by hand onto the burner
(avoid pouring as this can deposit fi ne dust in the
burner ports). Be careful not to completely block any
burner ports. You may not need to use the entire
ember mix.
42
3. Ensure the pilot light safe zone is not blocked by
embers. This is important to ensure proper ignition.
4. Select three rocks that will stand on a narrow edge,
and place them, one at each end of the burner, and
one behind the pilot hood.
5. Place the remaining rocks around the edge of the
burner.
6. Place the left hand logs (1 each of 1828 and 1827) as
pictured. Both should be arranged to arch over the
embers as much as possible instead of resting
directly on them.
Fuel Beds