Remote Control Set-Up - Valor LX1 Installation Manual

Installation
Remote Control - Radio Frequency
918.0 MHz for USA and Canada.
This device complies with Part 15 of the FCC
Rules and with Industry Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
Remote Control Initial Pairing
The receiver and the handset of the remote control sys-
tem must be initially paired before the fi rst use.
1. Insert two 1.5 V AAA
set.
2. Locate the Reset button on the front side of the re-
ceiver.
3. With a thin object, press and hold the receiver's RESET
button until you hear one short and one long beeps.
After the second beep, release the reset button.
4. Within the subsequent 20 seconds, press and hold
the button on the remote handset.
displayed on the handset during the pairing se-
quence. You will hear two short beeps confi rming the
pairing is done.
5. If you hear one long beep, the pairing sequence has
failed or the wiring is incorrect.
This is a one time pairing only and is not required when
changing the batteries of the handset or receiver. The
remote control system is now ready to use.
See "Appendix B - Remote Control Operation" on page
64 for full operating details.
alkaline batteries in the hand-
will be

Remote Control Set-Up

R E
S E
T
Receiver
location
45