Installation; Installing Electrical Wiring - Valor LX1 Installation Manual

Hide thumbs Also See for LX1:

Table of Contents

Installation

This section provides information to install the electric

wiring required for use with your ﬁ replace's lighting and

other options.

All wiring must be done by a qualiﬁ ed electrician in

accordance with local codes or, in the absence of local

codes, with the National Electrical Code, ANSI/NFPA 70

or the Canadian Electrical Code, CSA C22.1.

Electrical Requirements

120 V, 60 Hz, grounded supply, less than 1 amp.

General Requirements

The included V-Module power supply includes a three-

prong grounded plug to plug into a grounded receptacle,

also included with the ﬁ replace. The receptacle needs to

be wired up within the ﬁ replace enclosure by a qualiﬁ ed

electrician.

Installation

1. Locate the electric box at the wall end of the

ﬁ replace.

2. Remove the cover (4 screws).

3. Open the cover and pull out the 3 wires and terminal

blocks attached to the receptacle inside the box.

4. Punch out the cover knockout you want to pass the

supply wiring through.

5. Install strain relief (not supplied) and pass supply

wiring through. Do not tighten strain relief yet.

Electrical Wiring

Table of Contents