Replacing Light Bulbs - Valor 1400MN Owner's Manual

Direct vent gas fireplaces
Hide thumbs Also See for 1400MN:
Table of Contents

Advertisement

Replacing light bulbs

Decorative Lighting
This appliance is equipped with decorative lighting
located above the window.
The Decorative Lighting is operated by the remote
control—see Appendix A—Remote control operation on
page 25.
Required Bulbs
The two light bulbs in the H6 are 120V, 35 W bi-pin (JC)
halogen bulbs GY6.35.
Access to Light Bulbs
 WARNING
First, ensure the fi replace AND the lights
have been turned OFF for at least 60
minutes before you touch them. When
in function, both the fi replace and,
independently, the light bulb receptacles
are extremely hot!
Changing the light bulbs requires access to top of the
firebox. Remove the barrier screen, side doors and the
fireplace's window. See Remove Window on page 14 for
details about removing the window.
Light bulbs in shields located on top, outside of the
fi rebox—Remove window to access them
Wear gloves when changing these bulbs.
Most bulb manufacturers recommend no
skin contact as oil from skin can shorten
the bulbs' lifespan.
12
Replacing Light Bulbs
We recommend replacing both light bulbs at the same
time.
 WARNING
DO NOT access lamps from inside the
fi rebox!
1. Locate the light shields on top, outside of the fi re-
box.
Shield
securing
clips
Firebox edge
Firebox top
2. To replace the light bulbs:
a. Pull the right, then the left light shield straight
forward, out of the securing clips.
NOTE: If the clips are too tight, you can carefully
lift them slightly with a fl at blade screwdriver.
b. Carefully pull each light bulb out of its recep-
tacle.
c. With a gloved hand, carefully align the new bulb
pins with the receptacle holes and press into
place.
3. Test the lighting with the remote control handset
before reinstalling the shields (lighting can operate
independent of main fi re being on or off ).
4. Reinsert the left, then the right light shield back
into their corresponding securing clips.
NOTE: If you have lifted the securing clips, tighten
them back down.
5. Reinstall the window, side doors and barrier
screen.
Light shield

Advertisement

Table of Contents
loading

This manual is also suitable for:

H61400mp

Table of Contents