Table of Contents
Advertisement
2. While you hold it, pull the side levers back into the
window brackets on each side.
3. Pull out the top of the window and release it to
insure the springs return it.
4. Apply light hand pressure against the window frame
sides to bed-in the window seal.To refi t the window,
place it in its bottom railing and push its top against
the fi rebox.
5. While you hold it, pull the side levers back into the
window brackets on each side.
6. Pull out the top of the window and release it to
insure the springs return it.
IMPORTANT: To ensure a safe operation,
ensure that the spring-loaded mechanism
functions properly.
7. Apply light hand pressure against the window
frame sides to bed-in the window seal.
8. If the Hot Glass Warning plate has been
removed from the front lower corner
of the window, reinstall it by sliding
it between the glass and the frame as
indicated.
The receiver and the handset of the remote control
system must be initially synchronized before the fi rst
use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the fi rebox.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button (
) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Window Refi tting
Hot Glass Warning Plate
Remote Control Initial Set-up
QUALIFIED
INSTALLER
41
Advertisement
Table of Contents
