Table of Contents
Advertisement
1.
Place the window centrally against
the engine unit and resting on
the support at bottom front of the
engine.
.
Pull the clamping bars forward and
rotate inwards to secure the top of
the window.
.
Fit the two spring loaded bolts
through the bottom of the window
and tighten to secure the bottom of
the window.
.
Pull the top of the window forward
and release to ensure the springs
return it in position.
.
Similarly check the bottom of the
window by pulling it forward and
releasing.
.
Apply light hand pressure against
the window frame sides to bed in the
window seal.
The receiver and the handset of the remote control
system must be initially synchronized before the first
use.
1.
Insert batteries in the remote control receiver and
handset. The receiver is located left of the control
valve under the burner module.
.
With a sharp object, press and hold the receiver's
reset button until you hear two (2) acoustic signals.
After the second, longer acoustic signal, release the
reset button.
.
Within the subsequent 20 seconds, press the
(small flame) button on the remote handset until
you hear an additional long signal confirming the
sychronization is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
Window Refitting and Checking
Initial Remote Control Set-up
Advertisement
Table of Contents
