Table of Contents
Advertisement
Installation
Install Driftwood Kit 1000DWK
Material required
• Driftwood Log Kit, which contains:
• 9 logs
• 7 pebbles
• 1 x 0.180 lb bag of embers
• Gloves, if desired
H16
H15
f i r e - p a r t s . c o m
16
Installation
Carefully unpack the kit. Note each log and pebble has
its own number stamped on the bottom. Some logs have
pins and holes to help you place them on the burner
platform, or other logs.
Install the logs as shown below.
1. Place the shale embers into the recess in front of the
burner. Be careful not to overfi ll and block any burner
ports. (You may have more embers than you need!)
48
H17
H20
H19
H18
H21
H4
12
9
2. Place log H4 directly on the burner its underside
groove fi tting on the front raised fl ange of the burner;
slide the log all the way to the left.
H5
9
3. Place log H5 on the very right hand end of the burner.
You may have to gently press the log down onto the
ridge of the burner.
Fuel Beds
Advertisement
Table of Contents
