Table of Contents
Advertisement
Installation
Driftwood Kit 1000DWKV2
Material required
• Driftwood Log Kit, which contains:
• 8 logs
• 3 pebbles
• 1 cover plate
• 2 cups of embers, bagged
• Gloves, if desired
H36
H15
G4
Installation
Carefully unpack the kit. Note each log and pebble has
its own number stamped on the bottom. Some logs
have pins and holes to help you place them on the
burner platform, or other logs.
Install the logs as shown below.
1. Place the cover panel into the recess in front of the
burner.
H17
G15
H20
H22
H21
2. Place log G4 directly on the burner, its underside
groove fi tting on the front raised fl ange of the
burner. Slide the log all the way to the left.
3. Place log H15 onto the rear support bracket, and
slide it as far to the right as it will travel, gently
resting the log against the pilot shield.
H15
Fuel Beds
G4
G4
25
Advertisement
Table of Contents
