Starting Up The Cleaning Device; Prerequisites For Start-Up; Start-Up - Fronius Robacta Reamer V Easy Operating Instructions/Spare Parts List

Starting up the cleaning device

Prerequisites for The following requirements must be met before the cleaning device is started up:

start-up

-
-
-
-
-
-
-
-
-
-
-
-
Start-up The cleaning device starts up when there is an active signal from the robot control.
If present, the cleaning device installation stand is screwed to the underlying surface
The cleaning device is screwed to the underlying surface
The gas nozzle clamping device has been adjusted - not on the Robacta Reamer V
Easy Han6P J and if a gas nozzle with an outer diameter of 25 mm ( 0,98 inch) is used.
For more information, see "Adjusting the gas nozzle clamping device"
The cleaning cutter is fitted
The lifting device has been adjusted
If present, the wire cutter has been installed
If present, the parting agent nebuliser is started up
If present, the fill-level control sensor is started up
The compressed air supply has been established
The functions have been checked manually
The cleaning device is connected to the robot control
All coverings are fitted and all safety devices are intact and in their proper place
71