Cleaning The Gas Nozzle Tip And Nozzle Fitting - Detailed Description; Spraying Parting Agent - Detailed Description - Fronius Robacta TC 2000 Operating Instructions Manual

Cleaning the gas
NOTE!
nozzle tip and
During the cleaning operation, blow out the welding torch with compressed air
nozzle fitting -
detailed descrip- through the hosepack - any remaining dirt or parting agent is removed.
tion
2
3
Spraying parting
Applying parting agent evenly has the following advantages:
agent - detailed -
description -
NOTE!
If the brush seal (1) is fitted, note the changed reference point when positioning
the welding torch.
NOTE!
Ensure that the gas nozzle does not touch the housing components of the clean-
ing opening at any time.
50
(1)
Move the welding torch vertically into the cleaning position
- see figure
Begin cleaning and hold the welding torch for approximately 1 second in the
cleaning position
reduced welding spatter accumulation
prevents re-soiling
NOTE!
Ensure that the gas nozzle does not
touch the housing components of the
cleaning opening at any time.
Position the welding torch approx-
1
imately 50 mm (1.97 in.) centrally
above the middle of the cleaning
opening
NOTE!
If the brush seal (1) is fitted, note the
changed reference point when posi-
tioning the welding torch.