General; Principle; Illustration Of The Various Types; Device Concept - Robacta Reamer V Easy, Robacta Reamerv - Fronius Robacta Reamer V Easy Operating Instructions/Spare Parts List

General

Principle

Cleaning devices from the Robacta Reamer V series are used to automatically clean MIG/
MAG welding torches. The Robacta Reamer V series cleaning devices allow you to clean
the inside and front of the gas nozzle on a wide range of welding torch shapes. The result
is a significant increase in the service life of wearing parts. At the same time, evenly apply-
ing parting agent prevents the build-up of dirt.
Illustration of the
various types
Robacta Reamer V Easy Han6P J, Robacta Reamer V Easy, Robacta Reamer V
Device concept - The gas nozzle clamping device on the front of the cleaning devices holds the gas nozzle
Robacta Reamer in place during cleaning. A cleaning cutter is used to clean the nozzle. After the cleaning
V Easy, Robacta process, a parting agent is applied to the inside and front of the gas nozzle through the
Reamer V parting-agent injection nozzle that is fixed in the middle of the cleaning motor.
The options available for each cleaning device are shown on the following pages.
Device concept - The gas nozzle clamping device on the front of the Robacta Reamer V Easy Han6P J holds
Robacta Reamer the gas nozzle in place during cleaning. A cleaning cutter is used to clean the nozzle. After
V Easy Han6P J the cleaning process, a parting agent is applied to the inside and front of the gas nozzle
through the parting-agent injection nozzle that is fixed in the middle of the cleaning motor.
The Robacta Reamer V Easy Han6P J also has an adjustment that works as follows:
-
-
-
-
The manufacturer always screws all Robacta Reamer V Easy Han6P J to an adjust-
ment plate in the same position
The Robacta Reamer V Easy Han6P J is fitted to a mounting plate at the installation
location
Dowel pins interlock the Robacta Reamer V Easy Han6P J adjustment plate and the
mounting plate so that the Robacta Reamer V Easy Han6P J is always firmly fastened
to the mounting plate in the same position
As a result, when a device is replaced, the robot does not have much setting up to do.
Once the device is replaced, only the motor in the lifting device of the new cleaning
device has to be adjusted
17