Troubleshooting; Errors In Program Sequence - Fronius Robacta Reamer V Easy Operating Instructions/Spare Parts List

Troubleshooting

Errors in program Parting agent does not spray
sequence
Parting agent container is full
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Welding torch is poorly cleaned or damaged
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Not enough spray
Adjust spray amount (spray time or parting agent adjuster)
Parting agent hose suction filter in the parting agent container is soiled
Clean the parting agent hose suction filter with compressed air (see "Starting
up the parting agent nebuliser")
No signal from robot
Check robot program
Parting-agent injection nozzle blocked
Clean parting-agent injection nozzle
Contact After-Sales Service (arrange for parting-agent injection nozzle to be
replaced)
Vacuum pump faulty
Contact After-Sales Service (arrange for vacuum pump to be replaced)
Mechanical fault on solenoid valve
Contact After-Sales Service (arrange for solenoid valve to be replaced)
Position of the cleaning motor has been set incorrectly
Adjust the position of the cleaning motor
Gas nozzle clamped in wrong position
Adjust the gas nozzle clamping device
Cleaning cutter not suited to welding torch shape
Fit the correct cleaning cutter
Cleaning cutter is worn
Replace cleaning cutter
91