Srx 210 Services Gateway Installation; Installing The Srx 210 Services Gateway In A Rack; Installing The Srx 210 Services Gateway On A Desk; Installing The Srx 210 Services Gateway On A Wall - Juniper SRX 210 Services Hardware Manual

SRX 210 Services Gateway Hardware Guide

SRX 210 Services Gateway Installation

You can install the SRX 210 services gateway in a rack, on a desk, or on a wall. The
device includes rubber feet for desk and wall mounting. The mounting brackets are
an optional accessory.
Install the device as appropriate for your site using one of the following procedures:

Installing the SRX 210 Services Gateway in a Rack

You can front-mount the SRX 210 services gateway in a rack. The mounting brackets
are an optional accessory. Many types of racks are acceptable, including four-post
(telco) racks, enclosed cabinets, and open-frame racks. For more information about
the type of rack or cabinet the SRX 210 services gateway can be installed into, see
"SRX 210 Services Gateway Rack Requirements" on page 45.
NOTE:
To install the device in a rack:
60
SRX 210 Services Gateway Installation
SRX 210 Services Gateway Safety Requirements, Warnings, and
Guidelines on page 59
Installing the SRX 210 Services Gateway in a Rack on page 60
Installing the SRX 210 Services Gateway on a Desk on page 62
Installing the SRX 210 Services Gateway on a Wall on page 63
If you are installing multiple devices in one rack, install the lowest one first and
proceed upward in the rack.
Remove the rubber feet from the base of the chassis for rack installation.