Furuno FAR-2107 Series Service Manual page 89

This section describes minimum information required for settings and on equipment.
1. Calling up an operational menu: See page.4-1.
- INITIALZIZE menu:
Press the [Menu] key 5 times while holding down the [1: HL OFF] key.
- FACTORY menu:
Press the [2], [3] and [4] keys in order while holding down the [1: HL OFF] key.
2. Do not turn off the power immediately after changing the setting: See
page.4-1.
Do not turn off the power immediately after changing the setting of an "box" menu
and [Menu]. Wait for 6 seconds at least and then turn off the power. If the power is
turned off immediately after changing the setting, the setting may not be saved.
3. Changing of IP address: See page.4-19, 34 and 48.
After changing the radar number and the IP address setting of CU-200, restart the
units connected to the LAN including HUB-100.
4. Display of HDG, SPD and POSN: See page.3-5.
The display differs depending on the settings and sentences in use.
5. Notes for setting
Items that must be set up after installation are:
- All INITIALIZE menus in [Menu] –> 0: INITIALIZE
To be specific, make the following settings.
[Menu] -> 0 -> 2: Echo ADJ
[Menu] -> 0 -> 4: Installation
[Menu] -> 0 -> 5: Own ship Info
[Menu] -> 0 -> 6 -> 7 -> 3: ANT Select
- [Menu] –> 1 -> 2: TUNE INITIALIZE
- [OS POSN]
- [HDG]
- [SPD]
Note:
After making the "INSTALLATION" settings in the [INITIALIZE] menu,
restart the power.
Note)
: See page.7-23.
: See page.3-9, 4-50 and 6-13.
: See page.3-9 and 6-16.
: See page.3-10 and 6-16.
1
Introduction Introduction
See chapter 4